Removing and installing rear belt buckle, Transporter — AUDI
Removing and installing rear belt buckle, Transporter on Audi: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes SF, SG
📋 Procedure
- Remove seat .
- Remove left trim on seat.
- Remove bolt (3).
- Remove belt buckle (1) and cover plate (2) from seat frame.
- Remove bolts (8).
- Remove right belt buckle (7) from seat frame.
- Remove bolt (1).
- Remove cover plate (2) and release belt buckle (3) and belt end fitting (4) from seat frame.
- Pull belt buckle trim (5) out of seat padding.
- Using a small screwdriver, release retaining hooks (arrows).
- Remove lower part (6) of belt buckle trim (5).
- Pull belt buckle (3) downwards out of belt buckle trim.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Connecting fault reader V.A.G 1551 and selecting engine electronicscontrol unit
- Removing deposits from burner element (only when running on vegetable oil methyl ester)
- Testing intake air temperature sender (vehicles as of model year 1998)
- Replacing inner oil pipe
- Testing activation of solenoid valves
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.