Removing and installing radio navigation system "“RNS 4010”" — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

• Special tools named: locking bar

Don't miss

• Depending on the equipment level, 2 connectors may be present.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove any CDs left in the unit Operating manual.
3. Using removal wedge3409, carefully lever out centre console cover in area of (arrow).
4. Completely unclip cover (1).
5. Release and pull off connector (arrow). [Note: Depending on the equipment level, 2 connectors may be present.]

6. Unscrew 4 securing bolts (arrows) from radio navigation system.
7. Pull radio navigation system out of installation slot until connectors at rear of unit become accessible.
8. Pull off connectors of aerial wire (arrows).
9. Press together connector locking mechanism in direction of (arrows).
10. Swivel locking bar in direction of (arrow) while simultaneously pulling out connector.
11. Connect and engage connectors on radio navigation system.
12. ⚠ Risk of damage to display and operating keys!When inserting the radio navigation system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio navigation system never press against the display or operating keys. — Push radio navigation system in a straight line into installation slot in dash panel.
13. Install 4 securing bolts (arrows).
14. Install centre console cover.
15. Check coding of radio navigation system and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing suction jet pump with connecting piece
• Removing and installing selector lever cable on vehicles with 3.0 ltr. TDI engine with vehicle ID No. from 8E_8A 002700 onwards
• Removing and installing slave cylinder – Audi TT Mk1
• Checking fuel system pressurisation pump G6 (left-side) - electrical test
• Checking delivery rate of fuel pumps - vehicles with 8-cylinder engine