Removing and installing pump motor: Audi TT Mk2
Step-by-step removing and installing pump motor for the Audi TT Mk2: 4 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk2 (8J, 2006–2014)
- Opens: power steering fluid
- Renewed: seal
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Hydraulic fluid will escape when the pump motor is removed.Catch escaping hydraulic fluid with a suitable container and dispose of the fluid in the proper manner.Hydraulic fluid damages the paintwork. For this reason, immediately remove any hydraulic fluid which may drip onto painted surfaces. — Pump removed.
- Remove bolts (2) and pull motor off pump block (1).
- Fit new seal and install new motor (3) in pump block.
- Tighten bolts to 6 Nm. — 6 Nm (4.4 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking fuel low-pressure at high-pressure pump
- Removing and installing coolant union – Audi 2.5 TDI
- Removing and installing wiring harness for unit injectors
- Audi RS5 ancil belt removal
- Removing, installing, dismantling and assembling drive pinion
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.