Removing and installing poly V-belt, vehicles with air conditioner compressor — AUDI

🧭 Before you start

Fits: platform code FV

• Timing position: the crankshaft or camshaft is set and locked during this job

🔧 Engine codes this applies to

📋 Procedure

1. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
2. ⚠ If a used belt runs in the opposite direction when it is refitted, this can cause breakage.Before removing, mark direction of rotation of poly V-belt with chalk or felt-tip pen for re-installation. — To slacken poly V-belt turn tensioner in anti-clockwise direction (arrow) using ring spanner.
3. Lock tensioner with locking pin T10060A.
4. Take off poly V-belt.
5. Fit poly V-belt on poly V-belt pulleys:

6. Hold tensioner with ring spanner and remove locking pin T10060A.
7. Release tensioner.
8. Check that poly V-belt is properly seated.
9. Start engine and check that belt runs properly.

Other AUDI procedures

• Removing and installing intake air temperature sender G42 / intake manifold pressure sender G71
• Removing and installing engine mounting, Polo – VW CHZB/CHZC
• Removing and installing knock sensor 1G61 – Audi A6/A7 C7
• Removing and installing exhaust camshaft oil seal, pulley end
• Removing and installing camshaft adjuster for inlet camshaft
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures