Removing and installing particulate filter (right-side) — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

• Renewed: seals

Don't miss

• Disregard (item 1).
• Renew seals, gaskets and self-locking nuts.

🔧 Engine codes this applies to

📋 Procedure

1. ⚠ Working on all parts of the exhaust system:Observe safety precautions when working on the exhaust system . — Activate jacking mode 43.
2. Remove rear noise insulation panel (2)66.
3. ⚠ Avoid damage to flexible joints. Do NOT bend the flexible joints in the catalytic converter more than 10°. — Disconnect exhaust system at clamp (2). [Note: Disregard (item 1).]
4. Detach hose (1) going to pressure differential sender G505.
5. Remove temperature sender before particulate filter G506(item 2)

6. Remove nuts (3) and bolts (4) and (5) and detach particulate filter (right-side). [Note: Renew seals, gaskets and self-locking nuts.]
7. Install temperature sender before particulate filter G506.
8. Align the exhaust system so it is free of stress .
9. Install rear noise insulation 66.
10. Deactivate jacking mode 43.
11. After renewing particulate filter, perform adaption in "“Guided Functions”" mode vehicle diagnostic tester.

Other AUDI procedures

• Checking fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
• Removing and installing misfuelling prevention device – Audi
• Removing and installing exhaust gas recirculation control motor V338
• Removing and installing air cleaner housing (left and right)
• Removing and installing mounting plate for engine oil cooler, pressure control valve for crankcase breather system and oil filter housing
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures