Removing and installing oil filter bracket - engine code letters BDG, BDH — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

• Opens: coolant
• Renewed: seals

Don't miss

• Renew seals and O-rings.

🔧 Engine codes this applies to

📐 60 workshop diagrams for AFB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove starter catalytic converter: vehicles with front-wheel drive , vehicles with four-wheel drive .
2. Remove turbocharger .
3. Remove exhaust gas recirculation cooler .
4. Remove coolant pipe (rear right) .
5. Remove bolt (2).

6. Detach oil pipe (1).
7. Unscrew bolts (arrows) and remove oil filter bracket. [Note: Renew seals and O-rings.]
8. Install coolant pipe (rear right) .
9. Install exhaust gas recirculation cooler .
10. Install turbocharger .
11. Install starter catalytic converter: vehicles with front-wheel drive , vehicles with four-wheel drive .
12. Fill cooling system .

Other AUDI procedures

• Removing and installing fuel filter – Audi R8 · 1 torque figures
• Removing and installing glow plugs – Audi A8 D3 · 1 torque figures
• Checking charge pressure control solenoid valve N75 – Audi
• Removing and installing sealing flange (pulley end) – Audi
• Checking fuel pump relay J17 and activation - vehicles with 8-cylinder engine
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures