Removing and installing non-return valve (cylinder bank 2) — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017)

• Opens: coolant

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant .
2. Remove engine mounting (left-side) .
3. Unscrew bolts (arrows) and remove engine support (left-side).
4. Remove bolt (arrow).
5. Detach non-return valve (1).

6. Remove bolts (arrows).
7. Release hose clip (2) and detach coolant hose.
8. Detach non-return valve (1). [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
9. Install engine support and engine mounting .
10. Fill up with coolant .

Other AUDI procedures

• Checking fuel delivery rate of fuel system pressurisation pump G6 (in fuel tank) - A5 up to model year 2011, A4 up to model year 2012 (vehicles with front-wheel drive)
• Removing and installing exhaust gas temperature sender 1 G235 - vehicles with one turbocharger
• Removing and installing exhaust gas temperature sender 3 G495 - vehicles with one turbocharger
• Exploded view - silencers · 5 torque figures
• Exploded view - fuel tank · 3 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures