Removing and installing mounting/centre armrest - country-specific version — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

• Special tools named: T10383/1

📋 Procedure

1. Fold down centre armrest (rear).
2. Press trim cover (2) off armrest (rear) (1) using wedge T10383/1.
3. Guide trim cover out of guide rail (3)(arrow) and detach.
4. Remove mounting for centre armrest (rear) .
5. Remove bolts (4, 5, 6).

6. Position armrest (2) as shown in illustration.
7. Disengage trim (3) at top of centre armrest (arrows) and release retaining hook (1) on both sides.
8. Detach trim towards front.
9. Move clear wiring harness at centre armrest.
10. Unscrew bolt (4) at gas struts and detach washer (3).
11. Pull off relay lever (1) and press shaft (2) out to the side.
12. Detach armrest from centre armrest.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing MiniDisc player R153 – Audi A6 C6
• Removing and installing chip card reader control unit J676
• Removing and installing voice control system (from week 36/08 onwards)
• Removing and installing DVD player R7 – Audi A8 D3
• Bleeding fuel system after installing high-pressure pump - vehicles with engine codes BMK, BPP, BSG, BNG, ASB