Removing and installing mounting bracket with clutch master cylinder — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

• Opens: brake fluid, clutch fluid
• Special tools named: 3094
• Renewed: self-locking nuts

Don't miss

• In the following steps make sure that no brake fluid escapes onto the longitudinal member or onto the gearbox below. If this does happen, clean the affected area thoroughly.Place a cloth underneath to catch escaping brake fluid.
• Clamping off the supply hose with the hose clamp3094 will cause a permanent deformation.However, this does not damage the supply hose.After removing the hose clamp 3094, the supply hose must be returned to its original shape.
• (Item 1) can be disregarded.
• When working in the footwell, put cloths on the floor covering to protect it from possible brake fluid spills.
• Renew self-locking nuts.

📋 Procedure

1. Vehicles with 2.0 ltr. TDI engine: Remove air cleaner housing 23Air cleaner; Removing and installing air cleaner housing. [Note: In the following steps make sure that no brake fluid escapes onto the longitudinal member or onto the gearbox below. If this does happen, clean the affected area thoroughly.Place a cloth underneath to catch escaping brake fluid.]
2. Using hose clamp3094, clamp off supply hose to clutch master cylinder. [Note: Clamping off the supply hose with the hose clamp3094 will cause a permanent deformation.However, this does not damage the supply hose.After removing the hose clamp 3094, the supply hose must be returned to its original shape.]
3. Disconnect supply hose (1) from clutch master cylinder and plug hose using sealing tool T10249/1.
4. Release retaining clip (2) with a screwdriver and disconnect pipe/hose assembly (3) from clutch master cylinder.
5. Unclip clutch position sender G476(arrows A, B) and place it to one side with electrical connector attached. [Note: (Item 1) can be disregarded.]

6. Remove dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).
7. Remove crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel. [Note: When working in the footwell, put cloths on the floor covering to protect it from possible brake fluid spills.]
8. Remove nuts (1, 2).
9. Remove mounting bracket (3) with clutch master cylinder. [Note: Renew self-locking nuts.]
10. Push supply pipe onto connection on clutch master cylinder so that retaining clip snaps into place.
11. Pull on pipe to check that it is secure.
12. Bleed clutch system .
13. Install clutch position sender G476.
14. Install crash bar General body repairs, interior70Central tube for dash panel; Exploded view - central tube for dash panel.
15. Install dash panel cover (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel cover (driver side).
16. Install air cleaner housing 23Air cleaner; Removing and installing air cleaner housing.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Topping up gear oil in bevel box
• Removing and installing coolant pipes
• Removing and installing Lambda probe G39 with Lambda probe heater Z19
• Removing and installing engine cover panel – Audi Q7
• Renewing oil seal for vibration damper – Audi A3