Removing and installing motor for hydraulic pump for gearbox V387 — AUDI
Removing and installing motor for hydraulic pump for gearbox V387 on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 42
Don't miss
- For illustration purposes, the installation position is shown with the gearbox removed.
📋 Procedure
- Remove air cleaner housing Injection and ignition system24.
- Remove bolts (arrows) and detach heat shield. [Note: For illustration purposes, the installation position is shown with the gearbox removed.]
- Remove bolts (arrows) and remove motor for hydraulic pump for gearbox V387.
- Unplug electrical connector (1). [Note: For illustration purposes, the installation position is shown with the gearbox removed.]
- Insert connecting piece (3) in drive coupling on mechanical hydraulic pump (6).
- Clean foam insert (4).
- Fit foam insert (4) in bracket (5).
- Insert motor for hydraulic pump for gearbox V387(item 1) in bracket.
- Tighten bolts (2).
- Install air cleaner housing Injection and ignition system24.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing C-pillar trim – Audi A6 C6
- Removing and installing alternator - vehicles with 2.5 ltr. TFSI engine
- Removing and installing fuel delivery unit/fuel gauge senders, version for China
- Removing and installing fuel delivery unit/fuel gauge sender - vehicles with front-wheel drive
- Removing and installing upper transverse link · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.