Removing and installing mirror adjustment unit: Audi A8 D3
Step-by-step removing and installing mirror adjustment unit for the Audi A8 D3: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D3 (4E, 2002–2010)
Don't miss
- Grommet (3) must be inserted in door shell from outside.
📋 Procedure
- Door trim removed 70
- Mounting panel and window frame removed
- Unscrew bolt (3).
- Unplug electrical connector at window regulator control unit.
- Pull cable together with grommet through door shell and unclip from window frame
- Pull cable out of door and detach exterior mirror.
- Install in reverse order of removal.
- Window frame (1) removed
- On installing mirror, clip cable (2) into holes (arrows) in window frame.
- Grommet (3) must be inserted in door shell from outside.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Assembling body "„I"" – Audi A6 C5 / A8 D2
- Servicing automatic gearbox 01L, four-wheel drive — Exploded view - front final drive · 1 torque figures
- Servicing 6-speed manual gearbox 0A3, four-wheel drive — Dismantling and assembling centre differential housing
- Servicing 6-speed manual gearbox 0A2, front-wheel drive — Dismantling and assembling differential
- Removing and installing clutch - single-plate clutch, LuK version
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.