Removing and installing low range gearing hydraulic pump V190 — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Renewed: o-rings

📋 Procedure

1. Remove the front right wheel housing liner General body repairs, exterior66.
2. Screw out the bolts (arrow 1) and (arrow 2) (not visible in Fig.).
3. Remove the clip at connection (A) and detach the pressure pipe from the pump.
4. Seal the pipe with a suitable plug.
5. Unfasten the clamp (B) and detach the suction pipe from the pump.

6. Seal the pipe with a suitable plug.
7. Unplug the connector (C) and take out the pump. [Note: Replace O-rings.]
8. Insert the O-ring (2) in the groove (B).
9. Insert the O-rings (1) in the two grooves (A).
10. Attach the pressure pipe (A) to the hydraulic pump and fasten the clip.
11. Replace the clamp (B).
12. Attach the suction pipe to the hydraulic pump and secure it with the new clamp (B) .
13. Plug in the connector (C).
14. Screw the hydraulic pump to the holder.
15. Install the wheel housing liner General body repairs, exterior66.
16. Check the hydraulic fluid level for the low range gearing 6-speed manual gearbox 01E, four-wheel drive34.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing turbocharger (engine codes CEBA, CEBB, CECA, CECB)
• Emptying reducing agent tank (platform van and chassis)
• Removing and installing glow plug 1Q10 to glow plug 5Q14
• Removing and installing pan for hydraulic fluid
• Checking hydraulic fluid level