Removing and installing lines for clutch mechanism — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Opens: brake fluid, clutch fluid

Don't miss

• (Arrows) can be disregarded.

📋 Procedure

1. Remove complete air filter housing if it prevents access to the lines for clutch mechanism 24Air filter; Removing and installing air filter housing.
2. Remove battery and battery tray Electrical system27Battery; Removing and installing battery.
3. ⚠ Risk of leaking brake fluid.During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.Lay a lint-free cloth under clutch master cylinder. — Using hose clamp3094, clamp off supply hose (2) to clutch master cylinder. [Note: Clamping off the supply hose with the hose clamp3094 will cause a permanent deformation.However, this does not damage the supply hose.After removing the hose clamp3094, the supply hose must be returned to its original shape.The pipe/hose assembly (1) might differ slightly from the one shown in the illustration.]
4. Pull out clip for pipe/hose assembly (1) as far as stop, and pull pipe/hose assembly off clutch master cylinder.
5. Seal openings.

6. Lay a lint-free cloth under clutch slave cylinder.
7. Using a screwdriver, release securing clip (A).
8. Pull pipe/hose assembly (B) out of clutch slave cylinder (C), and seal openings. [Note: (Arrows) can be disregarded.]
9. Seal off open lines and connections if necessary with clean plugs from engine bung setVAS 6122.
10. Move pipe/hose assembly clear and remove it.
11. Push pipe/hose assembly(1) with seal (2) onto connection of clutch master cylinder and clutch slave cylinder (4) until clip (3) engages audibly.
12. Test line by tugging on it.
13. Bleed clutch mechanism .
14. Install battery tray and battery Electrical system27Battery; Removing and installing battery.
15. If removed, install complete air filter housing 24Air filter; Removing and installing air filter housing.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing roller blind in rear lid · 1 torque figures
• Removing and installing seat padding of front double bench seat · 1 torque figures
• Removing and installing heat exchanger housing (complete)
• Removing and installing brake caliper, Crafter 5.0 t
• Renewing centre bearing of two section propshaft