Removing and installing language input control unit J507 — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

Don't miss

• Seat belt at seat frame does not have to be unfastened.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove A-pillar trim (right-side): General body repairs, interior70Trim panels.
4. Remove front seat (right-side) General body repairs, interior72Front seats. [Note: Seat belt at seat frame does not have to be unfastened.]
5. Fold back floor covering: General body repairs, interior70Trim.

6. Release and detach cover for electronics box (arrows).
7. Unplug electrical connector (2) at language input control unit J507(1).
8. Take out language input control unit J507(1).
9. Installation is performed in reverse sequence.
10. If necessary, perform adaption and coding of language input control unit J507.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fog light, vehicles up to model year 2010 · 1 torque figures
• Removing and installing steering column switch module base
• Removing and installing steering column electronics control unit J527, manufacturer Valeo · 1 torque figures
• Checking variable intake manifold flap change-over valve N239
• Removing and installing right flange shaft