Removing and installing jump start socket U6: Audi A6/A7 C7

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• Disregard (items 1, 4).Illustration shows 3.0 ltr. TFSI engine.

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove engine mounting (right-side) 10Assembly mountings; Removing and installing engine mountings.
3. Remove nut (1) and move earth cable clear at engine support.
4. Remove bolts (arrows) and detach engine support (right-side).
5. Unplug connector (3) on starter (slide locking element towards rear and press down release catch).

6. Unscrew nut (2) and detach B+ wire from solenoid switch. [Note: Disregard (items 1, 4).Illustration shows 3.0 ltr. TFSI engine.]
7. Unplug electrical connectors (1) and (2) for radiator fan (slide locking element towards rear (arrow) and press down release catch).
8. Release fasteners (arrows) and move clear wiring guide (2).
9. Remove cap nut (1) and move clear earth cables.
10. Remove body brace Running gear, axles, steering40Suspension strut, upper links; Removing and installing body brace.
11. Remove air cleaner housing 23Air cleaner; Removing and installing air cleaner housing or 24Air cleaner; Removing and installing air cleaner housing.
12. Release catch (arrow A) and open cover (arrow B).
13. Detach electrical connector (1) from retainer and unplug.
14. Remove nuts (3, 4 and 5) and move clear electrical wiring and wiring harness (2).
15. Lift off foam wedge (1).
16. Remove bolts (arrows).
17. Lift out jump start socket U6 with wiring harness.
18. Connect battery. Steps required: vehicles without high-voltage system , vehicles with high-voltage system .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel pump delivery rate - FSI engine – Audi A2
• Removing and installing selector mechanism on vehicles with vehicle ID No. from 8E_8A 002700 onwards
• Removing and installing selector mechanism up to 09.98 – Audi
• Adjusting selector mechanism from 09.98 – Audi A3
• Automatic gearbox 01V, self-diagnosis — Final control diagnosis - gearbox with hydraulic control "“Type E18/2”"