Removing and installing infotainment system display - NAR vehicles — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

• Special tools named: 3409

📋 Procedure

1. Switch off ignition and all electrical equipment and remove ignition key.
2. Remove dash panel vents (centre) (do not unplug connectors) General body repairs, interior70Dash panel; Removing and installing dash panel vents.
3. Remove bolt (centre) (2) for display carrier (1) behind dash panel vents.
4. Pry display carrier (1) slightly out of dash panel (2) in direction of (arrow A) using removal wedgeVAS 3409.
5. Using a small screwdriver, compress spring catches in direction of (arrow B) and pry display carrier (1) out of dash panel (2) by pulling towards rear of vehicle.

6. Release and unplug connectors at display.
7. Unclip wiring harness for display from display carrier (1) and remove display carrier.
8. Unclip rear trim panel (2) from display and lift it off.
9. Remove bolts (5) and take display (4) out of display carrier (6).
10. Unclip front trim panel (1) from display (4).
11. If necessary, unclip side trims (3) (left and right) from rear trim panel (2).
12. Installation is carried out in reverse sequence; note the following:
13. Pay particular attention that the wires for the display are routed correctly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Installing gearbox - all vehicles with 6-cylinder engine · 1 torque figures
• Removing and installing rear final drive, Audi S1 – Audi A1
• Removing and installing hydraulic pump – Audi TT Mk1 · 3 torque figures
• Exploded view - intake manifold (bottom section) with fuel rail · 5 torque figures
• Removing gearbox - Audi Q5 with 2.0 ltr. TFSI engine