Removing and installing headlight main beam bulb M30/M32 — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Insert new bulb in housing; do not touch glass part of bulb with bare hands.

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Turn light switch to position "“0”".
3. Lift activated charcoal filter out of bracket (arrow) and place it aside with hoses still attached.
4. Detach cover (2) for main beam from headlight housing (arrow A).
5. Remove bulb (3) from spring clips (arrows B).

6. Unplug electrical connector (1) at main beam bulb.
7. Insert new bulb in housing; do not touch glass part of bulb with bare hands.
8. Position bulb at lower spring clip.
9. Push bulb beyond resistance of upper spring clips into housing.
10. Plug in connector and close housing cover.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Bleeding hydraulic system without brake filling and bleeding equipment · 1 torque figures
• Removing and installing propshaft with bolted connection at gearbox end
• Removing and installing condensers – Audi R8 · 1 torque figures
• Renewing oil seal for rear splined shaft, bevel box installed
• Exploded view - cylinder head (2.0 ltr. engine without assembly clearance feature) · 2 torque figures