Renewing headlight main beam bulb M30/M32: Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

• Renewed: bulb in housing

Don't miss

• Fit new bulb in housing; do not touch the glass part of the bulb with bare hands.

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Turn light switch to position "“0”".
3. Remove power steering reservoir .
4. Remove air cleaner housing .
5. Remove air cleaner housing .

6. Remove air cleaner housing .
7. Release retaining tabs (arrows) and detach housing cover from headlight housing.
8. Unplug electrical connector (1) at main beam bulb.
9. Disengage retaining clips (3) and (4) and take bulb (2) out of housing.
10. Fit new bulb in housing; do not touch the glass part of the bulb with bare hands.
11. Secure bulb with retaining clip.
12. Plug in connector and close housing cover.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing suction-jet pump (left-side), vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
• Checking and topping up ATF level – Audi A3 · 1 torque figures
• Separating engine and gearbox - vehicles with manual gearbox/R tronic gearbox 086 · 1 torque figures
• Dismantling and assembling drive shaft with triple roller joint AAR 3300i (with external splines for insertion in gearbox)
• Removing and installing bumper bracket – Audi A8 D3 · 2 torque figures