Removing and installing headlight dipped beam bulb: Audi TT Mk2

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Insert new bulb in housing; do not touch glass part of bulb with bare hands.

📋 Procedure

1. Remove headlight .
2. Remove screw (2) (if fitted).
3. Release retaining clip (arrow) and detach housing cover (1) for dipped beam headlight/daytime running light from headlight housing.
4. Unplug electrical connector (3) at bulb for dipped beam headlight/daytime running light.
5. Disengage retaining clip (2) and take bulb (1) out of housing.

6. Insert new bulb in housing; do not touch glass part of bulb with bare hands.
7. Secure bulb with retaining clip.
8. Plug in connector and close housing cover.
9. Secure housing cover with retaining clip.
10. Install headlight .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing right air duct with control motor for right side window defroster flap V410 · 2 torque figures
• Dismantling and assembling drive shaft, inner constant velocity joint
• Removing and installing solenoid valve block – Audi A6 C6 · 1 torque figures
• Dismantling and assembling drive shaft with 100 mm or 108 mm dia. inner sliding constant velocity joint
• Checking delivery pressure of power steering pump (vehicles with 6-cylinder diesel engine, vehicles with and without dynamic steering)