Removing and installing right air duct with control motor for right side window defroster flap V410 — AUDI
Removing and installing right air duct with control motor for right side window defroster flap V410 on Audi: 10 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code FV
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Remove bolts (2 |
| 3 Nm (2.2 lb-ft) | Remove the dash panel support (4 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Equipment version with ignition lock: Remove ignition key.
- Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box. [Note: Right-hand drive vehicles: Remove dash panel trim (driver side) General body repairs, interior68Shelves / trim panels; Removing and installing dash panel trim (driver side).]
- Remove the dash panel support (4) (tightening torque for bolts: 3 Nm)General body repairs, interior70Dash panel; Exploded view - dash panel. — 3 Nm (2.2 lb-ft)
- Remove the right side defroster vent (1).
- Remove bolts (2) (tightening torque: 1 Nm). — 1 Nm (0.7 lb-ft)
- Detach right air duct (4) with V410(3) from the air duct in the dash panel and swivel down.
- Unplug electrical connector on control motor V410(3).
- Remove control motor V410 from air duct (4).
- Renew damaged or defective foam seals.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing radiator - engine codes CUKB, CXUA
- Removing and installing Hall senders – Audi A3
- Servicing subframe, vehicles with aluminium subframe – Audi A3
- Removing and installing alternator - vehicles with 1.8 ltr. and 2.0 ltr. TFSI engine
- Renewing brake caliper - RS 3 (1LH, 1LU) – Audi A3
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.