Removing and installing guide rail for door window: Audi A4 B9

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

📋 Procedure

1. Move door window to "“open”" position.
2. Remove window frame trim General body repairs, interior70Door trim (rear); Removing and installing window frame trim.
3. Remove inner door cover .
4. Remove window regulator motor .
5. Detach window guide (1) slightly from C-pillar trim (2).

6. Remove bolt (arrow) for guide rail and press window guide into guide on C-pillar trim.
7. Move door window to "“closed”" position.
8. Pull window guide (3) off guide rail (4).
9. Remove bolt (1).
10. Detach guide rail towards front (arrow); this will release fastener (2).
11. Take out guide rail.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Routing wiring harnesses (8E1 970 XXX)
• Adjusting selector mechanism (vehicles up to 05.99) – Audi
• Renewing oil seal and grooved ball bearing for flange shaft (left-side)
• Removing cylinder head - engine codes AEB, AJL – Audi 1.8
• Removing cylinder head - engine codes ANB, APU, ARK, ATW