Removing and installing glove box - vehicles with knee bolster / knee airbag (country-specific version) — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

📋 Procedure

1. If fitted, remove knee airbag (front passenger side) .
2. Detach dash panel end trim (2).
3. Open glove box lid.
4. Loosen three bolts (4) at top in recesses of glove box (3).
5. Working from footwell, loosen bolts (5) (2x) from underneath.

6. Vehicles with CD changer (8): Slacken off bolt (6).
7. Slacken off bolts (9).
8. Vehicles with insulation box: Remove vent .
9. Take out glove box downwards.
10. Unplug connector (7) for glove box light.
11. Unplug connectors leading to electrical components in glove box, e.g. key-operated switch for front passenger's airbag.
12. Remove key-operated switch to deactivate airbag on front passenger side .
13. Detach dash panel end trim (right-side) (arrow) using front-end hook3370.
14. Press release mechanism (3) and pull connector (2) out of switch (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing drive shaft with 90 mm dia. outer constant velocity joint
• Bleeding fuel line to metering pump V54 (filling with fuel)
• Removing and installing refrigerant shut-off valve for high-voltage battery heat exchanger N542
• Removing and installing actuator for fresh air/air recirculation, air flow flap
• Renewing brake caliper (1LC/1LJ/1ZA/1ZD/1ZE/1ZP) – Audi A3