Removing and installing fuse holder (right A-pillar) — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• Exact assignment of contacts in fuse holder can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove glove box 68.
3. Remove right A-pillar trim 70.
4. Fold back floor covering in area of A-pillar.
5. Release retainer (2) and fold cover cap (1) to side (arrow).

6. Unscrew nut (4) for "“engine compartment”" battery cable.
7. Remove nuts (1 and 3) for wiring harness.
8. Remove nuts (arrows) securing fuse holder (2).
9. Detach fuse holder at A-pillar. [Note: Exact assignment of contacts in fuse holder can be found in applicable current flow diagram .]
10. Install right A-pillar trim 70.
11. Install glove box 68.
12. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing power steering pump (vehicles with 8-cyl. petrol engine with timing chain)
• Removing and installing aerial amplifier for mobile phone R86 (Saloon) · 2 torque figures
• Removing and installing radio/telephone aerial R51 (Saloon) · 2 torque figures
• Removing and installing wheel bearing housing (four-wheel drive vehicles)
• Removing and installing steering rack, 2nd generation