Removing and installing fuse holder: Audi A4 B5

🧭 Before you start

Fits: Audi A4 B5 (8D)

Don't miss

• Exact assignment of contacts in fuse holder can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove driver's storage compartment 68.
3. Unscrew bolts (B) for fuse holder (A).
4. Release top and bottom retaining clips (C) and detach fuse holder from central tube for dash panel.
5. Disengage wiring harness at central tube for dash panel and move it clear.

6. Cut open cable tie (1).
7. Release cover for fuse holder (arrows).
8. Detach fuses at fuse holder.
9. Detach retaining strip for connectors (arrows) and take connectors out of fuse holder.
10. Unclip socket (1). [Note: Exact assignment of contacts in fuse holder can be found in applicable current flow diagram .]
11. Install driver's storage compartment 68.
12. Connect battery. Additional steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing sump (bottom section) – Audi Q7 · 5 torque figures
• Removing camshaft timing chain from camshaft timing chain sprockets · 7 torque figures
• Retrofitting jump start terminal · 7 torque figures
• Removing and installing dash panel, Transporter · 7 torque figures
• Tightening torques for bevel box – Audi TT Mk2 · 9 torque figures