Removing and installing fuse holder at dash panel (right-side) — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Exact contact assignment of fuse holder in dash panel (right-side) can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove glove box 68.
3. Unscrew bolts (1) for fuse holder (2).
4. Release retaining tabs and detach fuse holder from central tube for dash panel.
5. Cut open cable tie (1).

6. Release cover for fuse holder (arrows).
7. Detach fuses at fuse holder.
8. Detach retaining strip for connectors (arrows) and take connectors out of fuse holder.
9. Unclip socket (1). [Note: Exact contact assignment of fuse holder in dash panel (right-side) can be found in applicable current flow diagram .] [Note: Refit all cable ties at the same locations when reinstalling.]
10. Install glove box 68.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing seat cushion extension motor – Audi
• Removing and installing backrest holder – Audi A8 D3 · 1 torque figures
• Automatic gearbox 01V, front-wheel drive and four-wheel drive — Renewing oil seals for flange shafts
• Adjusting selector mechanism - vehicles from 05.01 onwards, vehicle ID No. 4B-1-053 718 ▶
• Removing and installing injectors with fuel rail – Audi 2.7