Removing and installing fuse holder in dash panel (left-side) — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• The exact contact assignment of the fuse holder (dash panel) can be found in the applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove dash panel trim (bottom, driver's side) 68.
3. Remove bolt (1).
4. Slacken off bolt (3) by two turns.
5. Press fuse holder (2) off central tube for dash panel in direction of (arrow).

6. Cut open cable tie (1).
7. Release cover for fuse holder (arrows).
8. Detach fuses at fuse holder.
9. Pull off retaining strip for connectors (arrows) and take connectors out of fuse holder.
10. Unclip socket (1). [Note: The exact contact assignment of the fuse holder (dash panel) can be found in the applicable current flow diagram .] [Note: Refit all cable ties at the same locations when reinstalling.]
11. Install dash panel trim (bottom, driver's side) 68.
12. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling auxiliary heater (version “2”, vertical installation)
• Poly V-belt drive for power steering pump, alternator and air conditioner - exploded view of components
• Removing and installing input shaft, output shafts (pinion shafts), differential, bevel box and selector rods - gearboxes to approx. 04.2003
• Dismantling and assembling input shaft, output shafts (pinion shafts), differential, bevel box and selector rods - gearboxes from approx. 04.2003
• Sealing flanges and dual-mass flywheel/drive plate - exploded view of components