Removing and installing fuse carrier on 9-socket relay carrier — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

Don't miss

• Exact assignment for fuse carrier can be found on applicable current flow diagram .

📋 Procedure

1. ⚠ On vehicles with telematics system, activate service mode of telematics control unit before disconnecting battery Radio, telephone, navigation, self-diagnosis 01. Telematics self-diagnosis. — With the ignition switched off, disconnect the earth wire at the battery (see the separate procedure).
2. Press the light switch (arrow 1) and at the same time turn it to the right (arrow 2).
3. Hold the switch in this position and pull it out of the switch housing (arrow 3).
4. Unplug the connectors.
5. Remove the driver's storage compartment (repair group 68).

6. Remove nuts (arrows) from fuse carrier.
7. Remove fuse carrier (1) from 9-socket relay carrier. [Note: Exact assignment for fuse carrier can be found on applicable current flow diagram .]
8. Fit the driver's storage compartment (repair group 68).
9. Install the light switch (see the separate procedure).
10. Connect the battery. Action to be taken (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing door shell and door component carrier
• Repairing airbagä 06.92
• Renewing engine electronics control unit
• Check idling stabilisation valve -N71
• Checking intake manifold changeover valve -N156