Removing and installing front turn signal bulb M5/M7 - gas discharge headlights up to model year 2012 — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

📋 Procedure

1. ⚠ High voltage! Danger to life!Ensure that any part of the gas discharge headlights marked with yellow high-voltage warning symbols are de-energised when you are working on them.Switch off ignition and all electrical equipment and remove ignition key.Do not flash the headlights. — Remove headlight housing .
2. Release retaining clip (2)(arrow).
3. Swivel housing cover (1) to the side and detach.
4. Vehicles with cornering light: Unplug electrical connectors (1, 2, 3) at output module for headlight (4).
5. Turn bulb (1) anti-clockwise (arrow) and pull it out of housing.

6. Release retaining spring and unplug electrical connector at bulb.
7. Insert new bulb into headlight, taking care not to touch glass part of bulb with bare hands.
8. Close housing cover and secure with retaining clip.
9. Vehicles with cornering light: Install output module for headlight .
10. Install headlight housing .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing cables – Audi A8 D4 · 1 torque figures
• Dismantling and assembling peened triple roller joint AAR 3300 i
• Removing and installing coolant pipe (bottom left) - vehicles up to model year 2013
• Repair set, aerial cable VAS 6720
• Setting reverse gear clutch