Removing and installing front treble loudspeakers — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• Depending on the equipment level, 2 connectors may be present.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Using removal wedge3409, carefully lever out centre console cover in area of (arrows).
3. Completely unclip cover (1).
4. Release and pull off connector (arrow). [Note: Depending on the equipment level, 2 connectors may be present.]
5. Unscrew the two securing bolts (arrows) from dash panel trim.

6. Slightly pull out trim in direction of (arrow).
7. Unclip trim from dash panel (arrows) to remove.
8. Unclip loudspeaker trim (arrows).
9. Remove A-pillar trim General body repairs, interior70Pillar trims; Removing A-pillar trim.
10. Unscrew 2 securing bolts (arrows) from dash panel trim.
11. Unscrew 2 securing bolts (arrows) from dash panel trim.
12. Slightly lift trim, and unclip treble loudspeaker from trim (arrows) (wiring remains connected).
13. Release and pull off connector from loudspeaker (arrow).
14. Clip treble loudspeaker into removed dash panel trim so that the loudspeaker lug is seated correctly in the trim, as indicated by (arrow).
15. Only reconnect the loudspeaker connector when the trim with fitted loudspeaker is about to be reinserted into the dash panel.
16. Slide side trim into dash panel in direction of (arrow).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing poly V-belt for viscous fan
• Removing and installing Y-thermostat .
• Removing and installing housing (without lock cylinder)
• Removing and installing front airbag crash sensor for driver side G283/front airbag crash sensor for front passenger side G284
• Removing and installing centre floor covering, double cab