Removing and installing bass loudspeakers in doors: Audi A3
Step-by-step removing and installing bass loudspeakers in doors for the Audi A3: 7 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A3 (8L, 1996–2003)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolts |
| 2 Nm (1.5 lb-ft) | Unscrew bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove door trim General body repairs, Interior70.
- On back of door trim, carefully unfasten sound absorber (1) from trim in area of bass loudspeaker.
- Unplug connector at loudspeaker (2).
- Unscrew bolts (2 Nm) at bass loudspeaker (2) and detach loudspeaker from trim. — 2 Nm (1.5 lb-ft)
- Install accordingly in reverse order of removal.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing left flange shaft, 5-speed manual gearbox
- Removing and installing right drive shaft
- Removing and installing vane pump, 4-cylinder and 6-cylinder petrol engines
- Installing new adhesive pad for rain sensor
- Removing and installing headlights, headlights with H4 bulb
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.