Removing and installing front seat - RS bucket seat: Audi A4 B8

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

• Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.

📋 Procedure

1. With ignition switched on, disconnect battery earth wire Electrical system27Battery; Disconnecting and connecting battery.
2. Move seat as far upwards and back as possible.
3. Remove bolts (3).
4. Move seat forwards.
5. Remove belt end fitting (front) and guide out of belt guide.

6. Remove bolts (4).
7. Tilt front seat backwards.
8. Unplug connectors at connector point in floor .
9. Lift seat out of vehicle with the assistance of a second mechanic. [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.]
10. Plug in connectors at couplings of connector point in floor .
11. ⚠ The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. — With ignition switched on, connect battery earth wire Electrical system27Battery; Disconnecting and connecting battery.
12. Then interrogate event memory and erase any entries shown .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing wheel bearing
• Removing and installing radio system "“RCD 320 G”"
• Removing and installing aerial for AM/FM radio reception in left exterior mirror
• Removing and installing GPS aerial (GPS) in right exterior mirror
• Dismantling and assembling front propshaft