Removing and installing front seat cushion cover and padding — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Renewed: if necessary

📋 Procedure

1. Remove front seat .
2. Remove belt buckle
3. Remove seat trims .
4. Removing mounting for drawer, if fitted .
5. Remove backrest .

6. Unclip clamping bar (2) from seat frame (3).
7. If fitted, unclip connector of seat heating from retainer under seat.
8. Fold up front of cover until padding wire (6) is visible.
9. Squeeze clips (5) and remove cover (1) from padding (4).
10. Remove cover (4) from seat frame (3). [Note: Before installing, check all fasteners for damage and renew if necessary.Always replace clips (5) with clips of the typeN 015 261.1.Attach clips (5) using padding clip pliersV.A.G 1634.To aid installation, heat up cover (1) to approx. 30°C.]
11. Place padding (4) on seat frame (3).
12. Fasten cover (1) to padding (4) all round it with new upholstery clips (5) at positions indicated (6), using padding clip pliersV.A.G 1634.
13. Hook clamping bar (2) into seat frame (3).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing seat pan cover and padding (seats with manual or electric adjustment)
• Checking and adjusting selector lever cable - vehicles up to 11.2009
• Removing and installing starter - Audi TT with 3.2 ltr. MPI engine and manual gearbox
• Fitting run-flat tyres
• Checking for leaks, checking injection quantity and spray pattern of injectors