Removing and installing front seat belts — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. ⚠ Follow safety precautions for side airbag . — Disconnect vehicle battery 27.
2. Remove net partition .
3. Remove lower B-pillar trim, panel van .
4. Remove rear sill panel trim, panel van .
5. Remove lower B-pillar trim, Kombi .

6. Remove rear sill panel moulding (kombi) .
7. Unscrew bolt (1), remove belt anchor (2) and spacer sleeve (3) from body.
8. Remove belt inertia reel (4) of B-pillar.
9. ⚠ Electrostatic discharges may result in unintentional triggering of belt tensioner. Therefore, the mechanic must electrostatically discharge him/herself before disconnecting the igniter and earth wires. This can be done by briefly touching the body or striker plate of the door. — Disconnect wiring harness (5).
10. Remove bolts (6) and remove belt relay (7).
11. Swivel cap (8) up, remove bolt (9) and release belt anchor (10) from belt height adjuster.
12. Connect vehicle battery 27.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking injection quantity – Audi A8 D3
• Removing and installing additional ATF cooler – Audi A8 D3
• Checking for injectors sticking open (piezo injectors)
• Removing and installing Lambda probe before catalytic converter - bank 1 (right)
• Removing and installing oil retention valve and spray nozzle valve