Removing and installing front door trim, version B — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Renewed: if necessary

Don't miss

• The metal clips in the area of the inner door handle are seated very firmly and must be unclipped carefully.
• Before installing, check fasteners for damage and renew if necessary.

📋 Procedure

1. Switch off ignition and all electrical consumers. Remove ignition key.
2. Remove cover for front door trim .
3. Remove window handle if there is one .
4. If fitted, remove window regulator switch Electrical system96Lights and controls in front doors; Removing and installing window regulator switches in driver door.
5. Unclip cover (1) at bottom in (direction of arrow).

6. Using wedge T10383/1 unclip trim (2) from door trim.
7. Remove bolts (1).
8. Release door trim (1) from clip connections. Use wedges T10383 to do this. [Note: The metal clips in the area of the inner door handle are seated very firmly and must be unclipped carefully.]
9. Pull front door trim (1) vertically upwards out of window slot.
10. Depending on vehicle equipment, disconnect wiring harnesses and connectors from door trim. [Note: Before installing, check fasteners for damage and renew if necessary.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing brake caliper piston, floating caliper disc brake 2FNR
• Renewing small seal on bevel box between gearbox and bevel box
• Removing and installing map reading light L34 · 1 torque figures
• Removing and installing gas bottle
• Removing and installing additional battery in engine compartment · 1 torque figures