Removing and installing gas bottle — AUDI

🧭 Before you start

Fits: platform code SG

Don't miss

• Only "“Camping GAZ, type 907”" butane gas bottles in conjunction with a bottle safety valve may be used
• Open main shut-off valve and ensure that there are no leaks on gas line connections.

📋 Procedure

1. ⚠ Observe safety precautions: Liquid gas units . — Open rear cupboard doors.
2. Remove cupboard shelves.
3. Unscrew lid from gas bottle compartment.
4. Close main shut-off valve (1).
5. Unscrew union nut (2).

6. Detach pressure reducer (3) from gas bottle.
7. ⚠ If gas is smelt whilst removing the gas bottle ensure the vehicle is vented with fresh air immediately. Avoid sparks, fires and naked flames under all circumstances as long as gas is smelt and the cause has not been rectified - Danger of explosion! — Pull out clamping wedge (4).
8. Remove gas bottle from vehicle. [Note: Only "“Camping GAZ, type 907”" butane gas bottles in conjunction with a bottle safety valve may be used]
9. ⚠ Observe safety precautions: Liquid gas units . — Unscrew lid from gas bottle compartment.
10. Place gas bottle in container.
11. Secure pressure reducer with union nut to main shut-off valve (1).
12. Open main shut-off valve and ensure that there are no leaks on gas line connections.
13. ⚠ If gas is smelt whilst checking ensure the vehicle is vented with fresh air immediately. Avoid sparks, fires and naked flames under all circumstances as long as gas is smelt and the cause has not been rectified - Danger of explosion! — Close main shut-off valve.
14. Raise gas bottle slightly and insert clamping wedge at side in area of pressure reducer (3).
15. Check that gas bottle is securely positioned in gas bottle compartment.
16. Check that gas hose is not trapped, damaged or kinked.
17. Fit lid to gas bottle compartment.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling input shaft - exploded view
• Renewing flange shaft oil seals on gearbox
• Fitting locations in engine compartment – Audi CEUA/CGTA
• Checking seat heating (without seat ventilation)
• Removing and installing refrigerant temperature sender G454