Removing and installing map reading light L34 — AUDI
Removing and installing map reading light L34 on Audi: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T5 (7H), VW Transporter T6 (7E)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2.0 Nm (1.5 lb-ft) | Unscrew bolts for map reading light L34(arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Remove left upper B-pillar trim .
- Thread wiring harness (1) for map reading light L34 out through upper opening on B-pillar and disengage connector.
- Unscrew bolts for map reading light L34(arrows) (specified torque 2.0 Nm). — 2.0 Nm (1.5 lb-ft)
- Remove map reading light L34 with wiring harness.
- Install in reverse order of removal.
- Install left upper B-pillar trim .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing engine speed sender G28
- Checking backrest locking switch unit (microswitches)
- Removing and installing heater controls with heater control unit J65
- Checking air recirculation flap control motor V113 - automatically controlled air conditioner
- Removing and installing operating unit (Climatronic control unit J255) - automatically controlled air conditioner
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.