Removing and installing front central locking button - three-door vehicle — AUDI
Removing and installing front central locking button - three-door vehicle on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A3 (8P, 2003–2012)
📋 Procedure
- Switch off ignition and take out ignition key.
- Remove door trim (front) 70.
- Detach soundproofing mat from door trim in upper area.
- Unplug electrical connector (1).
- Pull bulb (2) out of holder at door release.
- Unscrew bolts (arrows).
- Take interior door handle out of door trim.
- Release clips (arrows) and press central locking switch (1) out of driver's door trim towards interior.
- Press central locking switch into switch mounting until fasteners engage.
- Install door trim (front) 70.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing left rear wing door window wiper motor V92, vehicles with rear wing doors
- Checking delivery pressure of fuel system pressurisation pump G6 - vehicles with supplementary fuel pump V393
- Removing and installing rear belt buckle, Transporter
- Removing and installing B-pillar trim, Multivan
- Removing and installing B-pillar trim, Transporter
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.