Removing and installing carrier for vehicles with central locking — AUDI
Removing and installing carrier for vehicles with central locking on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy IV (SA, 2015–2020)
📋 Procedure
- Remove rear wing door trim General body repairs, interior70Luggage compartment trims; Removing and installing lower rear lid trim.
- Remove interior operating mechanism .
- Unclip pull rod for lower lock (6).
- Unclip pull rod for relay lever (5) from carrier part.
- Unclip operating rod for interior door handle (3).
- Unclip Bowden cable for upper lock (4) from carrier part.
- Unscrew bolts (2).
- Pull out pull rod for exterior door handle (8) from carrier part (1).
- Remove carrier part (1) from rear wing door.
- Disconnect connector (7).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.