Removing and installing fresh air/recirculated air, air flow flap control motor V425 — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• The position of the air flow flap must not be changed.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical consumers.
2. Switch off ignition.
3. Remove ignition key.
4. Remove glove compartment 68.
5. Remove bolts (1) (1.4 Nm). — 1.4 Nm (1.0 lb-ft)
6. Turn control motor for fresh air and air recirculation flap and air flow flap V425(2) approx. 15° in direction of (arrow) and then pull off air intake housing.
7. Separate connector (1) from fresh air/recirculated air, air flow flap control motor V425. [Note: The position of the air flow flap must not be changed.] [Note: After installation, check operation of air flow flap and air recirculation flap.Initiate "“basic setting”" function using vehicle diagnosis, testing and information systemVAS 5051 (or successor model) .]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking adjustment of assembly mountings (engine/gearbox mountings)
• Removing and installing exhaust gas pressure sensor 1G450
• Removing and installing poly V-belt - vehicles with air conditioner compressor and tensioner
• Removing and installing exhaust gas recirculation control motor V338 with exhaust gas recirculation potentiometer G212
• Removing and installing three-point seat belt (rear) – Audi