Removing and installing engine mounting — AUDI
Removing and installing engine mounting on Audi: 16 steps, engines CAAA, CAAB, CAAC, CAAD. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
📐 31 workshop diagrams for CAAA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove air filter housing .
- Support engine in its installation position .
- Lift retaining clip (not visible in picture) and pull pressure hose (1) off charge air cooler (arrow).
- Unscrew bolt (2) from pressure pipe (1).
- ⚠ Do not loosen the screw-type clip (1) and pull back over the pressure hose. Risk of damage to the pressure hose! — Open screw-type clip (1) far enough to enable removal of pressure hose.
- Detach connecting hose on pulsation damper and lay aside.
- Remove plenum chamber bulkhead on left and right General body repairs, exterior50Bulkhead; Removing and installing bulkhead.
- If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation. [Note: The engine mounting may only be removed if the engine is supported with support bracket10 - 222 A!]
- Unscrew bolt (1) from engine mounting (5).
- Unscrew bolts (2) of engine carrier (4) out of engine support (3).
- Remove nut (2) and holder (1) for power-assisted steering pressure line.
- Unscrew bolts of engine support in sequence (3…1).
- Remove engine support.
- ⚠ The tightening sequence and specified torques for the engine support bolts must always be followed. Otherwise the engine support can be stressed and it can break. — Insert engine support.
- Tighten new bolts.
- Use the spindle to bring the engine support to rest on the engine mounting.
Ask TorqFix about your Audi CAAA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi CAAA — free → or sign up free to see the drawingsOther AUDI procedures
- Removing and installing accelerator module with accelerator position sender G79/G185 · 1 torque figures
- Removing and installing coolant temperature sender G62
- Checking vacuum hoses and vacuum switch for rear differential lock F363
- Removing and installing fuel rail
- Checking hydraulic compensation elements
- Removing and installing toothed belt · 56 torque figures
- Removing engine · 41 torque figures
- Removing camshaft timing chain from camshafts · 38 torque figures
- Installing engine · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.