Removing and installing drive plate with overload protection device (on vehicles with 8-cyl. FSI engine) — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• Use commercially available strap wrench (with fabric strap) to counterhold drive plate (C).

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove compressor .
2. Remove bolts (A). [Note: Use commercially available strap wrench (with fabric strap) to counterhold drive plate (C).]
3. Locate drive plate with overload protection device (B) on drive plate (C).
4. Insert and hand-tighten bolts (A).
5. Check concentricity of drive plate (B).
6. Tighten bolts (A) to final torque (10 Nm). — 10 Nm (7.4 lb-ft)
7. Check concentricity of drive plate (B) again .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing lower front coolant pipe
• Removing and installing left coolant pipes
• Removing and installing brake pads or linings
• Removing and installing axle beam, front-wheel drive
• Renewing desiccant bag for condenser, Caddy 2011 ►