Removing and installing coolant supply pipe (right-side) — AUDI

🧭 Before you start

Fits: platform code 42

• Opens: coolant

Don't miss

• The coolant hose (bottom arrow) can be accessed from the wheel housing (right-side).
• Do not reuse coolant.

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant completely .
2. Remove luggage compartment pan 70.
3. ⚠ To prevent irreparable damage to the electronic components when disconnecting the battery:Observe notes on procedure for disconnecting the battery. — Remove battery Electrical system27.
4. Place drip tray for workshop hoistVAS 6208 under connections.
5. Detach coolant hoses from coolant supply pipe (right-side) (arrows).

6. Remove bolts (1) and (2) and take off coolant supply pipe (right-side) downwards. [Note: The coolant hose (bottom arrow) can be accessed from the wheel housing (right-side).] [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
7. Fit coolant hoses and hose clips .
8. Install battery Electrical system27.
9. Install luggage compartment pan 70. [Note: Do not reuse coolant.]
10. Fill up with coolant .

Other AUDI procedures

• Checking fuel gauge sender 3G237 (bottom left sender)
• Checking fuel tank system for leaks - R8 Coupé – Audi 4.2
• Removing and installing vibration damper with poly V-belt pulley · 1 torque figures
• Removing and installing engine control unit 2J624 – Audi 4.2
• Removing and installing mounting plate – Audi A6 C6 5.0
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures