Removing and installing coolant supply pipe (left-side) — AUDI

🧭 Before you start

Fits: platform code 42

• Opens: coolant

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.
• Do not reuse coolant.

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant completely .
2. Remove luggage compartment pan 70.
3. ⚠ To prevent irreparable damage to the electronic components when disconnecting the battery:Observe notes on procedure for disconnecting the battery. — Remove battery Electrical system27.
4. Remove air intake unit (C)87.
5. Place drip tray for workshop hoistVAS 6208 under connections.

6. Detach coolant hoses from coolant supply pipe (left-side) (arrows).
7. Remove bolts (1) and (2).
8. Turn coolant supply pipe (left-side) upwards in clockwise direction and remove. [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
9. Fit coolant hoses and hose clips .
10. Install air intake unit 87.
11. Install battery Electrical system27.
12. Install luggage compartment pan 70. [Note: Do not reuse coolant.]
13. Fill up with coolant .

Other AUDI procedures

• Allocation of main bearing shells for new crankshaft
• Removing and installing drive chain for valve gear – Audi · 1 torque figures
• Removing engine - R8 Coupé with manual gearbox/R tronic gearbox 086 · 1 torque figures
• Removing engine - R8 Spyder with manual gearbox/R tronic gearbox 086 · 1 torque figures
• Removing engine - R8 Coupé with dual clutch gearbox 0BZ
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures