Removing and installing coolant pipes (right-side) - vehicles with auxiliary heater — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

• Special tools named: 3094

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📐 83 workshop diagrams for CAYB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove noise insulation (1)50.
2. Remove front wheel housing liner (front section, right-side) 66.
3. Remove bolt (3).
4. Loosen nut (2) and detach exhaust pipe (1) for auxiliary heater.
5. Remove bolts (2 and 4).

6. Clamp off coolant hoses using hose clamps 3094, release hose clips (1, 3) and disconnect coolant hoses.
7. Detach coolant pipes (right-side). [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
8. Install exhaust pipe for auxiliary heater 82.
9. Install front section of wheel housing liner (front) 66.
10. Install noise insulation 50.
11. Check coolant level .

Other AUDI procedures

• Checking fuel gauge G sender (CAYA, CAYB, CAYC) – VW 1.6 TDI
• Removing and installing intake manifold (vehicles with intake manifold flap V157)
• Removing and installing engine control unit J623 with anti-theft device, all vehicles apart from Jetta from MY 2011
• Toothed belt - exploded view
• Exploded view - poly V-belt drive with air conditioner compressor and tensioner
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures