Removing and installing right coolant pipes, Golf, Golf Plus, Golf Cabriolet, Passat, Touran, vehicles with auxiliary heater — VW
Removing and installing right coolant pipes, Golf, Golf Plus, Golf Cabriolet, Passat, Touran, vehicles with auxiliary heater on VW: 11 steps, engines.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015), VW Passat B6 (3C, 2005–2010), VW Golf VI (5K, 2008–2013), VW Golf Cabriolet (517, 2011–2016), VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014); platform code 521
Don't miss
- Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic Parts Catalogue (ETKA).
📐 66 workshop diagrams for CAYA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove noise insulation:
- Remove front right wheel housing liner: General body repairs, exterior66Wheel housing liner; Removing and installing wheel housing liner.
- Remove bolt (3).
- Loosen nut (2) and remove exhaust pipe for auxiliary heater (1).
- Remove bolts (2, 4).
- Clamp off coolant hoses with hose clamps 3094 and remove them. To do this, loosen hose clips (1, 3).
- Remove right coolant pipes. [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic Parts Catalogue.]
- Install exhaust pipe for auxiliary heater Auxiliary heater82Auxiliary heater; Removing and installing exhaust system.
- Install front wheel housing liner General body repairs, exterior66Wheel housing liner; Removing and installing wheel housing liner.
- Install noise insulation:
- Check coolant level.
Ask TorqFix about your VW CAYA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW CAYA — free → or sign up free to see the drawingsOther VW procedures
- Filling with coolant – VW Golf VII
- Removing and installing front coolant pipe, Golf, Golf Plus, Golf Cabriolet, Passat, Touran, vehicles with 4/2-way valve
- Removing and installing vacuum pump – VW Phaeton · 1 torque figures
- Removing and installing front coolant pipe, Polo – VW 1.6 TDI
- Checking oil pressure
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.