Removing and installing coolant pipes (bottom front) — AUDI
Removing and installing coolant pipes (bottom front) on Audi: 10 steps, engines BTR, CCFA, CCFC, CEUC.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018)
- Opens: coolant
Don't miss
- Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.
- Do not reuse coolant.
📋 Procedure
- Remove noise insulation (front) General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
- Remove front longitudinal member (bottom right) General body repairs, exterior50Lock carrier; Exploded view - lock carrier.
- Remove closure plate for bumper cover (front) General body repairs, exterior63Bumper (front); Removing and installing bumper cover.
- Remove nut (arrow) and move coolant pipe clear.
- Place drip tray for workshop hoistVAS 6208 under connection.
- Lift retaining clip (1), release hose clip (3), disconnect coolant hoses and drain off coolant.
- Remove bolt (4) and detach connection from coolant pipe.
- Release hose clip (arrow) and remove coolant pipes (front) to right side. [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
- Install closure plate for bumper cover General body repairs, exterior63Bumper (front); Removing and installing attachments. [Note: Do not reuse coolant.]
- Fill up with coolant .
Other AUDI procedures
- Removing and installing fuel pump G23, vehicles with 6.0 ltr. (V12) engine
- Removing and installing oil pressure switch F22 – Audi A3
- Removing and installing exhaust gas recirculation control motor 2V339
- Removing and installing air filter element (left-side), cylinder bank 2
- Checking fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.