Removing and installing coolant pipe (top) on engine — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

• Opens: coolant
• Renewed: o-ring

Don't miss

• Fit new O-ring.Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant .
2. Remove turbocharger .
3. Remove intake manifold 23.
4. Release hose clip (1), lift retaining clip (2) and detach coolant hoses.
5. Remove bolts (arrows) and detach coolant pipe (top) from cylinder head. [Note: Fit new O-ring.Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]

6. Clean and smoothen sealing surface for O-ring.
7. Lubricate O-ring with coolant and slide onto coolant pipe.
8. Install intake manifold 23.
9. Install turbocharger .
10. Connect coolant hose with plug-in connector .
11. Fill up with coolant .

Other AUDI procedures

• Removing and installing exhaust gas recirculation control motor V338
• Checking fuel pumps (electrical test), vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010 and vehicles with 6.0 ltr. (V12) engine
• Removing and installing suction-jet pump (left-side), vehicles with 6.0 ltr. (V12) engine
• Removing and installing suction-jet pump (right-side), vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
• Removing and installing coolant pipe (bottom left) on engine
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures