Removing and installing compressor temperature sender for adaptive suspension system G290 — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Air supply unit is removed in illustration.
• The electrical wiring should only be secured at the points marked (arrows).

📋 Procedure

1. Position vehicle on lifting platform .
2. Remove noise insulation 50.
3. Remove wheel.
4. Remove wheel housing liner (front right) 66.
5. Unclip and unplug connectors (2). [Note: Air supply unit is removed in illustration.]

6. Remove bolt (1) and pull out compressor temperature sender for adaptive suspension system(3).
7. Lubricate O-rings (4) with grease provided.
8. Slide in compressor temperature sender for adaptive suspension system(3) as far as stop in housing (2).
9. Screw in and tighten bolt (1) to specified torque .
10. Plug in connector (2) and clip on electrical wiring. [Note: The electrical wiring should only be secured at the points marked (arrows).]
11. Fit noise insulation 50.
12. Install wheel housing liner (front right) 66.
13. Fit wheel.
14. Stand vehicle on its wheels .
15. Secure wheel Wheels and tyres44.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures