Removing and installing charge air cooler - vehicles with hybrid drive — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

🔧 Engine codes this applies to

📋 Procedure

1. Remove impact absorber General body repairs, exterior63Bumper (front); Removing and installing impact absorber.
2. Move breather hose (2) for headlight housing clear.
3. Release fasteners (arrow).
4. Carefully press air duct (1) towards front of vehicle.
5. Release hose clip (arrow) and detach air hose from charge air cooler.

6. Remove bolt (1).
7. Release hose clip (1) and detach air hose from charge air cooler.
8. Push catch down (arrow A) and move top of charge air cooler slightly in direction of (arrow B).
9. Lift charge air cooler off radiator, paying special attention to air duct (left-side). [Note: If there are slight impressions on the fins, refer to .Hose connections and air pipes and hoses must be free of oil and grease before assembly.Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.To ensure that the air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing.]
10. Install air hose .
11. Install impact absorber General body repairs, exterior63Bumper (front); Removing and installing impact absorber.

Other AUDI procedures

• Checking fuel system pressurisation pump G6 - A5/S5/RS 5 up to model year 2011, A4 up to model year 2012
• Removing and installing oil pressure switch F22 – Audi A3
• Removing and installing Lambda probe after catalytic converter G130
• Exploded view - cylinder block (pulley end), vehicles with hydraulic power steering · 1 torque figures
• Checking fuel gauge sender 2G169 - A5 up to model year 2011, A4 up to model year 2012, rest-of-world vehicles with four-wheel drive, USA vehicles with front-wheel drive/four-wheel drive
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures