Removing and installing centre head restraint blind: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Make sure the blind is properly engaged on both sides.

📋 Procedure

1. Remove the rear seat bench .
2. Remove the rear seat backrest .
3. Remove the centre head restraint .
4. Prise out the blind (2) on the left and right at the locations marked (1) (2x).
5. Disengage the blind (2) on the left and right at the locations marked (3) (2x) and detach the blind (2).

6. If the old blind is re-installed:
7. Roll up the blind (2).
8. Hold the pin (4) with pliers and turn the blind 14-15 times in the direction opposite to extension direction (arrow).
9. Press in the pin (4) and secure the pin (4) with a paper clip for example.
10. Engage the blind (2) in the guides (1). Start on the side with locking element.
11. Make sure the blind is properly engaged on both sides.
12. Pull out the locking element (3).
13. Check operation of the blind. At least 3/4 retraction

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures